18
4.
Place media roll on label supply spindle. Replace
label roll guard. Make sure the label roll guard position
of each sides are the same as the length of the label.
Please check the outside edge scales are both close
to the label width.
5.
Pull label roll leading edge forward through the media
guide bar, media sensor (green) and place the label
leading edge onto the platen roller.
6.
The media sensor position is moveable. Please make
sure the gap or black mark is at the location where
media gap/black mark will pass through for sensing.
Note:
* The sensor location is marked by a triangle mark
▽
at the sensor housing.
