TSC MH261T Series, User Manual, Page: 39 / 68

34
Note: If printing from enclosed software/driver, the software/driver will send out the commands, which will overwrite the settings set from the
panel.
Item Description Default
Speed Set the print speed
203 dpi: 6
300 dpi: 4
Slew Speed
Set feed speed
203 dpi: 6
300 dpi: 4
Back Speed Set back speed 2
Density
Set printing darkness. Setting range: 0 to 15, and the step is 1.
8
Direction
Set the printout direction. Setting Value: 0 and 1.
Direction 0: Direction 1:
0
Print mode
Set the print mode. There are 6 modes in total:
None: Next label top of form is aligned to the print head burn line location. (Tear Off Mode)
Batch Mode: Once finishing the printing process, label will be fed to the tear plate location.
Peeler Mode: Enable the label peel off mode.
Cutter Mode : Enable the label cutter mode.
Cutter Batch: Cut the label once at the end of the printing job.
Rewinder Mode: Enable the label rewinder mode.
Applicator : The printer prints a label when it receives a signal from the applicator.
Batch
Mode
Offset Adjust media stop location. Available value setting range: -999 dots to 999 dots. 0 dot
Shift X
Adjust print position. Available value setting range: -999 dots to 999 dots.
0 dot
Shift Y 0 dot
Reference X
Set the origin of printer coordinate system horizontally and vertically. Available setting range: 0 dot to
999 dots.
0 dot
Reference Y 0 dot
Code page
Set the code page of international character set.
850
Country
Set the country code
001