TSC MH261T Series, User Manual

Page: 24 / 68

19
Wrinkle happens from label left to
upper right direction
1.
Decrease the right side knob’s pressure per level to see whether the wrinkle is gone or not.
2.
If the right side adjustment knob has been set to 1 , please increase the left
side one’s pressure.
3.
If right side knob has been set to 1 and the left 5 but the wrinkle still exists, please set the both
knobs back to 1, then rotate the
Z-axis mechanism adjustment knob clockwise for a few
degrees and print again for fine tune the print head pressure distribution.
Pressure level:5>4>3>2>1
Note for step 3:

Factory default setting, the Z-axis knob is rotated counter clockwise to the end of thread.

Turn the Z-axis mechanism adjustment knob clockwise until you feel the knob touch the
mechanism for the first adjustment.

If the wrinkle is still there, please turn the Z-axis mechanism adjustment knob clockwise about 1/4
circle each time for adjustment

If the winkled direction is change from
“/” to “\” by adjusting the Z-axis mechanism adjustment
knob, please turn the Z axis mechanism adjustment knob counter clockwise to avoid the wrinkle.
Wrinkle happens from label lower
right to upper left direction
1.
Decrease the left side knob’s pressure per level to see whether the wrinkle is gone or not.
2.
If the left side adjustment knob has been set to 1, please increase the right
side one’s pressure.