Doc. # 5016
BM-185D/285D/286D
Rev. A
Operation and Service Manual
3.0
OPERATING INSTRUCTIONS
3.1 GENERAL OVERVIEW
When the BM-185D/285D/286D is initially installed at its operating location, the operating
parameters must be adjusted to meet the local conditions and testing requirements. Most of the
adjustments are accessed via the software set-up mode.
A touch screen keyboard will appear any time you are required to enter data into the system.
Use of the provided stylus will help in accessing buttons and entering information.
A "Set-Up Checklist and a Waste Stream Programming Worksheet" can be found at the end of
this section. The Set-Up Checklist should be duplicated and filled in for each test source that will
be used with the system. A copy of the completed form should be kept in a convenient location
as a reference for identifying future problems. The Waste Stream Programming Worksheet
contains entries for each of the operating parameters in the individual waste streams. The system
permits up to 20 pre-programmed waste streams, and the form may be copied as required to
assist in programming these waste streams.
The set-up mode is password protected, with two levels of user access provided. Both level 0 and
level 1 operators have access to the normal operation of the BM-185D/285D/286D. Operators
with level 0 (administrative) access may change operating parameters and change discriminator
settings.
Determining the operating parameters is largely dependent on local requirements and conditions.
PAGE 12
