Trynex SnowEx Vee Pro 3000, Owner'S/Operator'S Manual

Page: 33 / 44

© Trynex International 2007 L1102
5 — 33
Vibrator Kit Model #OFK-020
Wiring Diagram and Installation
Key Part No. Description Qty.
 D 4124 3/8'' Lock Nut 4
 D 6160 3/8'' - 16x2 Hex Bolt 4
 D 6161 DC-80 Vibrator 1
 D 6163 Vibrator Washer 4
 D 6184 On/Off Switch 1
 D 6233 10 Amp Fuse 1
 D 6234 Butt Connector 1
 D 6344 Dielectric Grease 1
 D 6403 20' Universal Harness 1
 D 6404 10' Battery Harness 1
 D 6406 Rubber Switch Boot 1
 D 6425 Fuse Holder 1
 D 7105 Ring Terminal 2
 D 7106 Spade Connector 2

(+) Pos.Red
(–) Neg. Black



(–) Neg. Black
(+) Pos.Red




12 VOLT
BATTERY
Wiring Installation and Instructions
Step 1: First, install switch at desired location. This will determine
what the proper wire length should be.
Step 2: Run spreader/vehicle harness from the rear of vehicle to
switch area. Remove approx. 3'' of the black outer jacket exposing
two single leads (red and black), strip a 1/4'' off each lead. Crimp
1/4'' female connector on red lead and crimp the butt connector to
the black lead. Place the female spade/red wire to the on/off switch
and leave the black wire for the next step.
Step 3: Route the power harness from the battery to the switch;
this will determine proper length to cut wires. Repeat step #2
regarding cable jacketing and connection points to the switch and
butt connector.
Step 4: Install an inline 10 amp. fuse on the positive (red) lead from
the battery to the switch. Locate an easily accessible place, out of
the elements, for the fuse and remove approx. 3'' of the black outer jacket exposing two single leads (red and black). Cut the red lead in
half and strip a 1/4'' off each lead. Insert into the fuse connector and crimp. Insert 10 amp. blade fuse into connector.
Step 5: At the battery end of the power harness, remove 8'' of the black outer jacket exposing two single leads (red and black). Strip 1/4''
off each lead. Crimp a 3/8'' lug terminal to each lead and attach the red lead to the positive side of the battery and the black lead to the
negative side of the battery.
Step 6: Locate vibrator approx. 6" to 8" from the top of throat entry and drill four 3/8" holes in rear hopper face. Bolt the vibrator in place
using special washers with domed side against hopper.
IMPORTANT: It is imperative that SPECIAL DOMED WASHERS are used. Use of any other washer could cause hopper to tear.