Trynex SnowEx SP-9500, Owner'S/Operator'S Manual

Page: 24 / 40

L1185 © Trynex International 2009
5— 24
Mount Kit Mounting Instructions
Model # HMK-175
Step 1: For dump trucks remove tailgate, and for platform bodies remove rear racks.
Step 2: Load spreader on to truck bed and mount spinner assembly.
Step 3: Slide spreader forward until deflector/chute assembly makes contact with vehicle. Then, slide spreader back approx. 1" to
allow for proper clearance.
Step 4: Install rear stop bars using supplied hole patterns (see Fig.2). To achieve the best position, you may need to drill additional
(see Fig.2)
holes in bracket in order to properly position spreader.
Step 4-A: Install front stops using supplied hole patterns (see Fig.1). You will need to bolt through the body.
Step 5: Now that the spreader is positioned front to back, you will now center it left to right. Looking at the inside front and rear
corner of the lower frame area, you will notice (4) holes in the bottom of the frame. Using a paint pen or similar marking device, mark
hole locations.
Step 6: Before drilling holes, look beneath the approximate area where each hole will be located. Make sure there are no
vehicle components that will be in the path of the drill before doing this step. If there are interferences, you can relocate holes as
needed making sure there are at least two forward and two rearward of the front to back centerline.
Step 7: Install and tighten all (4) bolts.
Step 8: Install ratchet straps (see V-Maxx 9500 Mounting System: Strapping Techniques). It is very important for everyone’s
safety this strapping method be used as the standard mounting procedure. NOTE: (Do not use ratchet straps exclusively.)
Step 9: Connect the spreader power cord to vehicle main power plug mounted at rear of vehicle (see Electrical Installation).