TruVision 6 IP Series, Installation Manual

Page: 4 / 44

• Please make sure that the plug is firmly connected to the
power socket. When the device is mounted on a wall or
ceiling, it should be firmly fixed to the surface.
• If smoke, odor or noise rises from the device, turn off the
power at once and unplug the power cable. Then please
contact the service center.
• Proper configuration of all passwords and other security
settings is the responsibility of the installer and/or end-
user.
Cautions
• Make sure the power supply voltage is correct before
using the camera.
• Do not drop the camera or subject it to physical shock.
• Do not touch sensor modules with fingers. If cleaning is
necessary, use clean cloth with a bit of ethanol and wipe
it gently. If the camera will not be used for an extended
period, please replace the lens cap to protect the sensor
from dirt.
• Do not aim the camera at the sun or extra bright places.
Blooming or smearing may occur otherwise (which is not
a malfunction), and affect the endurance of sensor at the
same time.
• The sensor may be burned out by a laser beam, so when
any laser equipment is in using, make sure that the
surface of sensor will not be exposed to the laser beam.
• Do not place the camera in extremely hot, cold (the
operating temperature is-30°C ~+60°C, or -40°C ~ +60°C
if the camera model has an “H” in its suffix), dusty or
damp locations, and do not expose it to high
electromagnetic radiation.