Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
9
Figure 2-5
8.
Select appropriate mounting locations for the AP Master, AP Circuit Breaker,
Emergency Level and control wheel steering switches. Connect these items per
the Vizion wiring diagram in the Vizion PMA Installation Guide (TruTrak Doc.
166).
8.1.
All items in this step are required to be installed. The AP Master Switch,
AP Circuit Breaker, and Control Wheel Steering switches must be
labeled. The Control Wheel Steering Switch must be RED.
9.
Connect GPS inputs per the Vizion wiring diagram in Vizion PMA Installation
Guide (TruTrak Doc. 166)
10.
Conduct pitot / static check of aircraft system before opening any pitot/
static connections!
11.
Mount autopilot controller in panel using 4 6-32 X 3/8” screws. Connect wiring
harness and connect pitot and static per Vizion PMA Installation Guide (TruTrak
Doc. 166).
12.
Install Vizion Limitations Placard (Trutrak P/N 8300-092) near the Vizion
autopilot. A sample panel with potential placard location is shown below:
