Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
12
3.2.
Cessna C180, C182-C182D, C185 Roll Servo Mounting Instructions
NOTE: Apply torque seal to all bolts after final torquing is achieved.
1.
The roll servo will be mounted in the left wing just forward of the inboard end of
the aileron.
1.1.
Begin by removing the inspection cover on the lower wing skin located forward
of the inboard end of the aileron.
1.2.
Figure 3-1shows the roll servo mounting location from below the left wing.
Figure 3-1
2.
The Cessna 18X Upper Roll Bracket (P/N 1450-127) will be mounted to the flange
of the rear wing spar using 3 ea. AN526C-832R8 screws.
2.1.
Locate the inboard screw hole as shown in Figure 3-2 on the upper wing skin.
