Trusted Clean TPL-17-200-CE-HEAT-TCP, Owner'S Manual, Page: 3 / 13

GROUNDING INSTRUCTIONS
The 120V A/C and the 220V A/C models have been outfitted with the appropriate
grounded connectors. Make sure the machine is connected to a grounded outlet
having the same configuration as the grounded plug. No adapter should be used with
this machine. Any modification to the connectors will void the warranty.
PREPARING THE MACHINE (ALL GALAXY EQUIPMENT)
IMPORTANT: For all Galaxy equipment, use only the correct high pressure, high heat wands & uphol
-
stery tools. They are designed to deliver and maintain the correct gallons per minute (GPM), pressure (PSI)
and heat when attached to the GALAXY pump system. Use of other manufacturer wands can cause over-
wetting of carpet, damage to the pump system (including hose & fittings), lack of pressure and heat.
1. Pour clean solution into the solution tank.
2. Slide vacuum hose onto the black hose adapter (located at the back of the machine) and the wand or
upholstery tool.
3. Connect the male end of the solution hose to the wand and the female end to the machine by sliding
knurled collar on the female quick disconnect fitting back. Push the male fitting in and release the knurled
collar until it snaps back.
4. Make sure the drain valve is closed by pushing the T-handle all the way in.
5. Previously shampooed carpets usually have a heavy build-up of old shampoo residue which can cause
the vacuum system to ingest foam and result in damage to the vacuum motor. Remember to add recom-
mended amount of defoamer to the recovery tank every time you fill the solution tank.
6. If a Powermate is to be used with the machine, connect the male plug on the wand to the optional
receptacle on the machine.
Additional Instructions for GALAXY’s with HEAT’N’RUN installed:
1. Be sure to fill the solution tank with water before plugging in the machine.
2. Water hookups must be in place and water flowing through the heater prior to turning it on. Failure to do
so may cause internal component damage and will void the warranty.
3. Spray water through the tool / wand before turning on the heater to assure that there is water flow.
4. Heater must be filled with water or water based solutions at all times when in use.
5. Plug heater power cord and machine power cord into separate outlets on separate circuits.
6. Turn off the switch and unplug the heater from outlet when not in use.
7. Do not use heater
with any other machine than this adjustable PSI Galaxy
.
8. Turn on heater switch when you are ready to clean.
CAUTION: When the green light on the heater is on, the heater is heating. When the green light is off, the
water in the heater tank is up to temperature and the thermostat switch in the heater has turned the heater
off. It will automatically turn on again when the water temperature in the heater has cooled.
DELIVER MAXIMUM HEAT by performing the following SYSTEM WARM-UP PROCEDURES at the start of
each day:
1. Attach the solution hose to the quick disconnect on the machine.
2. Attach the warm-up quick disconnect with spray tip attached to the other end of the solution hose.
3. Place warm-up quick disconnect in the solution tank.
4. Fill solution tank with cleaning solution.
5. Turn on pump.
6. When water is flowing out of the warm-up quick disconnect, turn on the heater.
7. Let the pump and heater run for 4 to 5 minutes.
8. Remove warm-up quick disconnect. Attach the wand or upholstery tool and begin cleaning.
1
2
3
6
4
5
7
8
9
10
11
12
13
14
15 16
18
19
17
20 22
34
26
27
24
28
29
26
21
23 25
32
31 30
37
38
35 36
40
41
39
42 43
44
46
47
45
51 52 50 48 49
53
7
54
55
10
58
59
21
60
42
64 65
66 67
5
69
71
3
70
7
7
49
21
17
2000FX-HR Base
12-19-07
2000FX-HR Base
12-19-07
62
56 57
39
68
61
33
29
63
21
ITEM
NO.
PART NUMBER DESCRIPTION QTY.
1 C00297 #8 X .25 Pan Head 1
2 J11863 Hose, 3 in 1
3 J00639 Screw Clamp, 1.63 - 2.43in. 3
4 J00618 Vacuum Hose, 2in Grey, Wire, 22 in lg 1
5 C00273 Locknut, 1-4 X 20, Nylon, SS 16
6 F11178-BLK Intercooler, Galaxy, Black 1
7 C00233 Washer, Flat, .25 in 26
8 E00449 Grommet 6
9 C00284 Screw, 10-32 X .375 Ground 2
10 B11150 Ground Wire, Galaxy 2
11 G02522L Vacuum , 135 in, 115 V, 5.7 in 2
12 J00657 Hose Clamp, 2 inSLDPRT 1
13 J00618 Vacuum Hose, 2 in Grey, Wire, 4 in lg 1
14 C00261 Nut, .25-20, Hex 10
15 C00254 Lock Washer, 1-4in Split 1
16 D11134 Vac Plate 1
17 C11189 Screw, 1-4 X 20 X 4.5 in, Hex 5
18 C02312 Lockwasher, .25 in., Internal Star 1
19 C11516 Screw, 1-4 X 20 X 4.5 in, Flat Head, Phillips 1
20 J11154 Solution Hose, .375, 100PSI, Wire, 31 in lg 1
21 J11508 Screw Clamp #6, .43 to .875 in 8
22 G11904 Power Prime 1
23 A00060 .25 Male X .375 Barb, Brass 1
24 A00053 45 Elbow, .25MP X .25 FP 1
25 G03523-1 Valve, Regulator, 200 PSI 1
26 A00052 90 Elbow, .25MP X .25FP 3
27 00580-13in-MF-A Hose Asm, 13 in X .25HP 1
28 G00516-3 Gauge, 0-600PSI 1
29 C11244 Washer, .56 X 1.5 X .05 4
30 A00104 QD, 1-4 M X 1-4 FP, Brass 1
31 A00161 Tee, .25 FP, Brass 1
32 A00111 Nipple, .25 in 2
33 C00232 Washer, .5 in, Flat 1
34 A00154 90 Elbow, .25 NPT X .25 NPT 1
35 C11440 Spacer, Heater Mounting Plate 4
36 K10510 Plug, 1.25 in, Black 1
37 C02322 Hex Bolt,1-4 X 20 X 1.75 in 4
38 D010379 Heater Mounting Plate 1
39 C11165, Screw, #8 X 1 in, Pan, Black 5
40 F11790 Heater, Tunnel Cover, Blue Granite 1
41 B11779 Stub, 12-3 SJTW Yellow 2
42 B00191 Nylon Tie, 11in Black 4
43 C00293 #8 X .5in Pan, Black SMS, Phillips 2
44 B00192 Tie Holder with Glue 1
45 B11606 Strain Relief, Pigtail 2
46 H03545 Cover, Serial # Label 1
47 H00565-5 Label, Serial Number 1
48 C02305 Cap Nut, .5in Push-on 2
49 C00240 Washer, Shoulder, Nylon 4
50 G11767 Wheel, 10 in 2
51 D11170 Axle 1
52 F11789 Base 1
53 C00314-1 Hex Bolt, 1-4 X 20 X 1in 8
54 G03518 Caster, 4 in 2
55 G13102 Pump, 500 PSI, 120 V 1
56 B00177 Terminal Lug, Female, QD, .25 X .032, 16-14 AWG, Fully Insulated 2
57 C03251 Washer, .187 ID, Backup 1
58 A00168 Bushing .375 M X .25 F Brass 4
59 A90004 .50 Barb X .25 MP, Brass 1
60 A00155 Male Plug, .25 in, Nylon 1
61 J11933 Hose, .5 in Polywire PVC, 33 in lg 1
62 J00632 Pulse Hose, Pump - QD, 42 in 2
63 B00190 Nylon Tie, 4in 13
64 D13103 Plate, Pump, Galaxy, Flat 1
65 H02564-2 Label, Caution, Motor Housing 1
66 J11933 Hose, .5 in Polywire, 30 in 1
67 K11935 Strainer, Inline, .5 in 1
68 J11154 Solution Hose, .375, 100PSI, Wire, 27 in lg 1
69 J00618 Vacuum Hose, 2 in Grey, Wire, 7 in lg 1
70 E11169 Gasket, Vac Motor, Galaxy 2
71 B00179-2 Closed End Cntr, 16-3 6