Truper ROU-A3, Manual

Page: 7 / 24

Cutting depth adjustment
Start Up
•
For fine cutting depths adjust,
turn the triple depth stop ( E )
loosening the central screw to align
one of the three threaded stops
with the depth stop (
D
).
7
B
C
A
D
B
E
B
D
F
E
D
E
ENGLISH
• Install the bit ( A ) needed for
the job. Loosen the fastening
knob in the depth stop ( B )
and loosen the cutting depth
safety lock ( C ) moving it up.
• Push the router down until
the bit makes contact with the
work piece and secure it in
position moving the cutting
depth lock lever (
C
)
downwards.
• For fast cutting depth adjust raise the depth stop ( D )
and insert a piece of wood having the same thickness of
the work piece, between the depth stop ( D ) and the triple
stop (
E
).
• Tighten the stop-fastening knob ( B ) and move the
cutting depth lock lever (
C
) upwards to return the router
to its original position. Remove the piece of wood.
• For exact cutting depths adjust, allow the depth stop
to make contact with the triple stop so it shows the initial
position in the cutting depth scale ( F ). This position may
vary regarding the bit used.
• From the starting position and with the help of the scale,
rise the depth stop as much as the depth required for the
job. If the starting position marks 20 mm on the scale and
you require a cut of 10 mm, put
the depth stop at the 30 mm
mark (20 + 10 = 30).