Truper 16706, Manual

Page: 7 / 24

Start up and operation control
Chuck
Bit
Chuck
wrench
Bit fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck wrench and tighten alternatively the chuck into
each of the orifices.
7
Start up
• Intermittent operation:
Connect the plug into the power outlet.
Press the switch ( A ) to start the drill.
To stop, just release the switch.
• Continuous operation:
Connect the plug into the power outlet.
Press the switch ( A ) and block it pressing the continuous use button ( B ).
To stop, press and then, release the switch.
A
A
D
C
D
B
Speed control
• The tool can operate in different speeds. These can be selected adjusting the
speed control (
C
). Turn the speed control in a clockwise direction to increase the
Drill speed. Turn in a counterclockwise direction to decrease speed.
Rotation direction
• To get the bit to rotate forward and drill, move the rotation selector lever ( D )
towards the arrow pointing the chuck.
• To get the bit go reverse and use the tool as a drill, move the rotation selector lever
towards the arrow pointing the drill handle.
• Set the drill in a regular operation position. The rotation direction lever shall be
placed in the right side of the trigger (seen from the back) to operate the tool as a
drill or as shown in the figure.
Rotation selector lever
in the drilling position
ENGLISH