7
Start up
ENGLISH
Installation of the Saw Blade
• With the jig saw in an inverted position turn the fast
support (
A
) counterclockwise. Fully insert the saw blade
into the saw blade slot (
B
) with the cutting teeth to the
front. Release the support to let the jaw catching the saw
blade.
• Try to move the saw blade to double check it is firmly
secured.
• Double check the saw blade is properly set and it can
easily run in the roller guide slot (
C
). Otherwise the
balancing action will not work right and the saw blade will
not be supported while cutting.
• Use only the saw blade type shown.
Speed Control
Speed Guide
• The tool can run in different speeds. These are selected by
adjusting the speed control found in the tool rear side (
F
).
• Adjust speed with the speed control according to the
material, its thickness and the blade specification you will
use (it is also possible doing it while operating no-load).
See the speed guide to select them.
• Avoid using the tool in low speed in
long periods of time. The tool’s motor can get damaged.
Start Up and Operation Control
• Intermittent Operation:
Connect the plug into the power outlet.
Press the switch (
D
) to start the tool.
To stop the tool, simply release the switch.
• Continuous Operation:
Connect the plug into the power outlet.
Press the switch (
D
) and block it pressing the continuous
use button (
E
).
To stop the tool, press and release the switch.
Material
Speed
Wood
Metal
Aluminum
PVC
Ceramics
5-MAX
3-4
3-5
3-4
3-5
To gain better cutting
results double check you
are using the saw blade
assigned for the material
and cutting quality you
look for.
CAUTION
WARNING
D
A
E
F
B
C
The work light turns on
when the switch is pressed.
