Truper 12464, Manual

Page: 7 / 32

Parts
Unpacking and assembly
7
2
5
3
19
18
17
18
21
14
24
7
14
2
20
17
10
30
30
29
14
16
15
15
11
4
1
13
1
Mounting onto a work bench
Cutter head release
Due to tight quality controls there is a small probability that the tool has defects or missing parts. If there is any problem,
before using the tool and to prevent severe injury, please go to a Authorized Service Center
• Remove all loose parts from the packaging before
unpacking the tool.
• Remove the packing material around the tool.
• Carefully lift the saw grasping only by the carrying handle
(
5
). Sit the unit onto a totally leveled surface.
• Always carry the tool with the cutter head set down and
blocked with the release knob (
2
). Lift the saw only using
the carrying handle and / or the extension arms ( 21 ).
Prevent back injury. Seek help to lift the saw.
• Find four orifices in each one of the four supports to fix the
base onto a worktable.
• Fix the base onto a perfectly leveled worktable. Use
screws (not included).
• Or, fix the base onto 1/2” or larger piece of plywood to
be able to fasten the board to the table or to carry it to
different work places.
• Assembling the tool onto a warped,
tilted or irregular surface will cause uneven cuts.
WARNING
• Once the tool is assembled, use the release knob (
2
) to
free the cutter head and use the saw.
• Press down the cutter head while pulling out the release
knob. Turn it 45° and release.
• Then, slowly lift the cutter head.
• To lock the cutter head back set it down while pulling out
the release knob. Turn it -45° and release.
ENGLISH