10
Mounting
1
Lock nut
wrench
Inner
flange
5/8-11-UCN-1A
Grinder
head
External
flange
Disc
1.
Fit the inner flange onto the axis.
2.
Set the disc onto the inner flange.
3.
Set the outer flange onto the axis.
• Press the axis lock into the grinder head.
4.
Screw the outer flange with the lock nut wrench until
securely fastened.
The shaft lock must only be used to
change the discs. Never to stop the disc while it is rotating.
• Always use flanges in perfect condition, of the correct size
according to the shape of the selected disc.
• A flange with the correct characteristics supports the
blade, which reduces the possibility of blade breakage.
Flanges for cutting discs can be different from flanges for
grinding discs.
• The grinding surface of discs with a sunken center should
be installed below the plane of the guard.
• An improperly installed disk can project burrs outside the
plane of the guard and cannot be properly protected.
Disc Assembly
• Open the clamp lever and match the protruding parts on the inside of the guard
protection, push the guard protection down until the protruding parts engage and
rotate freely with the corresponding slots in the shaft cover.
• With the clamp lever open, rotate the protection guard to the desired working
position.
• Secure it by pushing the clamp lever.
Protection guard mounting
2
3
4
DANGER
Auxiliary handle assembly
• For safe operation use the auxiliary handle, place it
in one of the three mounting holes to make your
work easier.
Protective
guard
Slot
ENGLISH
