Truper Expert 102111, Manual

Page: 9 / 28

1 2 3 4
Turning On
1. Open the water faucet and keep it open all the time you are using the washer. Maximum inlet pressure: 174 PSI
2. Connect the plug into the power supply.
3. Tighten and hold the high-pressure gun trigger to release the air caught inside the washer. Release the trigger when the
water flow is constant.
4. Turn the switch ( C ) into the ON position. The motor will start momentarily and then it will stop.
C
D
E
9
Spraying
• Always hold the gun and lance with both hands to control
the sudden movement produced by the pressurized water.
Detergent Use
Start Up
• Aim the lance towards the floor and press
the gun trigger to start spraying.
• To stop spraying, release the trigger.
3
ENGLISH
ATE
• Use only detergents designed for pressure washers.
Never use products with bleach, chlorine or other corrosive agents such
as solvents, trisodium phosphate products, ammonia or acid-based
cleaners. These products cause damage to the machine components.
• Remove the cap of the detergent tank (
E
) and add the appropriate
detergent. Do not add water to the detergent tank, the machine will
automatically mix the detergent with the water.
ATENC
• The machine will only suction detergent when
operating at low pressure. Mount the soap nozzle (black color) on the
lance.
• Squeeze the trigger, the detergent will come out mixed with the water.
If you need to adjust the detergent flow, turn the detergent switch ( E ), to
the left to decrease and to the right to increase, depending on the job to
be done.
• Apply detergent to completely cover the cleaning surface.
• Turn off the spray gun and allow the detergent to remain on the
surface to be cleaned for a couple of minutes.
• Switch to other nozzles to enter high pressure cleaning mode to rinse
and remove detergent from the surface.
WARNING
WARNING