1
Cutting tool
7
Clamping screw
18 Lubricate the grease nipple with
a grease gun
20 Carrier
F
"S1" lubricating grease
Fig. 20849
1. Undo the clamping screw (7).
2. Rotate supporting body (20) by 45°.
3. Pull supporting body (20) out towards the bottom.
4. Screw out the cutting tool (1).
5. Grease the square part of the cutting tool and the bore hole
of the carrier slightly with "S1" lubricating grease (order num-
ber 0121486).
6. Check the penetration depth of the punch with the setting
gauge (order number 1411767).
5.3
Change the sliding sleeve
If the clearance between liner and cutting tool is >0.3 mm, then
the liner must be changed.
32
Maintenance
E681en_02
