−
Hold down the release inhibiter knob (1) and press the
on/off switch (2).
−
Release the on/off switch (2).
The switch remains engaged. The motor is running.
or
Ø
To switch the machine to instantaneous connection:
−
Hold down the release inhibiter knob (1) and press the
on/off switch (2).
−
Release the release inhibiter knob (1).
The motor is running.
3. When full speed has been reached: move the machine
4. Machine the desired cutting line.
5. In the event that the cutting track ends in the sheet: pull the
machine (still running) a few millimeters back towards where
the cutting track has already been cut open
6. Immediately press and release the on/off switch (2).
Changing the cutting direction
In situations where space is limited, the tool can be mounted in
such a way as to have a different cutting direction
For cutting profiles: mount the tool at an angle of 90° either
to the left or to the right.
For nibbling to the rear: mount the tool at an angle of 180°.
The following requirements must be met when nibbling with tem-
plates:
■
The template must be at least 5 mm thick.
■
There must be a clearance of 11 mm between the contour of
the template and the contour to be nibbled out.
■
The nibbler must be guided in such a way that the exterior
cutout of the punch guide (5) always remains up against the
template.
■
Observe a minimum bending radius of 135 mm.
16
Nibbling with templates
2011-04
E528EN_06
