Trumpf TruTool F 301, Operator'S Manual

Page: 14 / 20

14
Operation
E607EN_01.DOC
The machine cannot be placed up against the beginning of the
channel.
Preparation of the channel so that the machine can be brought into
position.
1
1 Preformed suspension lug
1. Move setting lever (1) into position against the direction of
feed ("Tool open").
2. Set machine up against desired (prepared) position on the
channel.
3. Position setting lever (1) in direction of feed ("Tool in work
position").
–
The working direction (direction of feed) of the machine is
determined by its design.
4. Switch on the machine.
5. Close the lock seam.
6. Move setting lever (1) into "Tool open" position.
7. Switch off machine and remove from the machining position.
Note
•
A minor refinishing operation (length approximately 130 mm)
must be carried out manually at the end of the channel
following the use of the seam locker.
¾
Release lever.
The lever springs back to the initial position and the compressed
air is interrupted.
Flange at the beginning of
the channel
Fig. 13412
Switching off