25
– Damage arising from foreign substances (e.g. oils, plasticis-
ers in the gas), chemical or electrochemical influences in
the water, or cases when the unit has come into contact
with unsuitable substances (e.g. chemical products, unsuit-
able cleaning agents)
– Damage caused by abnormal environmental or unsuitable
operating conditions
– Damage caused by force majeure or natural disasters or
any other influences not within Truma’s responsibility
– Damage resulting from improper transport
3. Making a warranty claim
The warranty must be claimed with an authorised service part-
ner or at the Truma Service Centre. All the relevant addresses
and phone numbers can be found at www.truma.com, in the
“Service” section.
To ensure a smooth procedure, we should be grateful if you
could have the following details ready before contacting us:
– Detailed description of the defect
– Serial number of the unit
– Date of purchase
The authorised service partner or the Truma Service Centre
will then specify the further procedure. To avoid transport
damage, the affected unit must only be shipped upon prior
arrangement with the authorised service partner or the Truma
Service Centre.
If the warranty claim is recognised by the Manufacturer, then
the transport expenses shall be borne by the same. If no war-
ranty claim is applicable, the Consumer will be notified ac-
cordingly and any repair and transport expenses shall then be
the Consumer’s liability. We must ask you not to send in a unit
without prior arrangement.
Installation instructions
Safety instructions
This device contains parts that could cause sparks or a
light arc!
Only qualified technicians may assemble and connect electri-
cal devices!
The solar module generates power when light is cast on it.
The full voltage is also available even if there is little light. The
open circuit voltage may be twice as high. Do not touch any
live parts. Cover solar modules with e.g. cardboard, before
mounting and installing.
The device was developed for the connection of solar mod-
ules. Only use suitable modules e.g. Truma SM 65, SM 100
or SM 150. Observe the maximum voltage and power draw
values.
Only use the specified cable cross-sections and fuses of the
correct strength!
Do not install or operate the device in wet rooms (e.g. bath-
rooms) or in rooms in which highly flammable gas mixes can
develop.
The installation of the device must comply with the techni-
cal and administrative provisions of the respective country in
which it is used (e.g. EN 1648). National regulations and laws
must be observed. National regulations and laws must be
observed.
