Truma BGA 14 Operating And Installation Instructions Download Page 3

3

General safety notes

The use of upright gas cylinders from which 
gas 

is taken in the gas phase

 is mandatory 

for the operation of gas regulators, gas equip-
ment and gas systems. Gas cylinders from 
which gas is taken in the liquid phase (e. g. for 
fork lifts) must not be used, since they would 
result in damage to the gas system.

In the event of leaks in the gas system or if 
there is a smell of gas:

 

– extinguish all naked flames

 

– do not smoke

 

– switch off all appliances

 

– shut off the gas cylinder

 

– open the windows and doors

 

– do not actuate any electrical switches

 

– have the entire system checked by an 

expert!

Repairs may only be carried out by an 
expert.

 

– This device may be used by children aged 8 

years or above and by persons with reduced 
physical, sensory or mental capabilities or 
lack of experience and / or knowledge, only 
if they are supervised or have been given 
instruction with regard to the safe use of the 
device and have understood the potential 
risks. Children must not use the device as a 
toy. 

 

– To avoid the risk of accidental resetting of 

the over-temperature guard, the device may 
not be supplied with power via an external 
contactor, such as a timer, nor may it be 
connected to a power circuit that is regularly 
switched on or off via a device.

Danger

Failure to operate the relief valve at least once 
every six months may result in the water heat-
er splitting.  Continuous leakage of water from 
the valve may indicate a problem with the wa-
ter heater!

 

– Water may drip from the discharge pipe of 

the  pres sure relief device and this pipe must 
be left open to the atmosphere.

 

– The pres sure relief device is to be operated 

regularly to remove lime deposits and to en-
sure that it is not blocked.

 

– Any discharge pipe connected to the safety 

(pres sure relief) valve is to be installed in a 
continuously downward direction and in a 
frost free ambient.

 

– Before accessing terminals, please ensure 

all supply circuits are disconnected (i.e. 
230 V – 240 V and 12 V) and that the gas 
supply is securely turned off.

 

– Any work involving connection or intercon-

necting wiring must be carried out by a li-
censed electrician.

 

– Any modifications to the unit, including ac-

cessories and cowl, or the use of spare parts 
and accessories that are important to the 
operation of the system that are not original 
Truma parts and failure to follow the installa-
tion and operating instructions will void the 
warranty and release Truma from any liabil-
ity claims. It also becomes illegal to use the 
appliance, and in some countries this even 
makes it illegal to use the vehicle.

 

– The operating pressure for the gas supply is 

2.75 kPa (AUS – Propane) and must corre-
spond to the operating pressure of the appli-
ance (see data plate).

 

– LPG systems and pressure regulators must 

comply with the technical and administra-
tive regulations of the country in which the 
appliance is used. For your own safety it is 
 absolutely necessary to have the complete 
gas installation regularly checked by an ex-
pert (at least every 2 years). The vehicle own-
er is always responsible for arranging the 
gas inspection.

 

– Do not operate when travelling.

 

– Do not operate the water heater when refuel-

ling the vehicle and when it is in the garage.

 

– Items sensitive to heat (e. g. spray cans) 

must not be stored in the installation area, 
since excess temperatures may occur there 
under certain circumstances.

 

– During the initial operation of a brand new 

appliance (or after it has not been used for 
some time), a slight amount of fumes and a 
slight smell may be noticed for a short while.

Summary of Contents for BGA 14

















Reviews: