9
TRUE
undercounter
and
worktop
freezers
www
.
truemfg
.
com
STARTUP
A. The compressor is ready to operate. Plug in the freezer.
IF CABINET DOES NOT COOL AFTER ONE HOUR
REFER TO THE FULL INSTALLATION MANUAL
ON-LINE AT WWW.TRUEMFG.COM.
B. Temperature controls are factory-set to give refrigerators an
approximate temperature of 35°F and freezers an approximate
temperature of -10°F. Allow unit to function several hours,
completely cooling cabinet before changing the control setting.
Temperature Control Location and Settings.
• Electronic temperature control is located on rear of unit or
behind access grill.
• LAE temperature control is located on the front of cabinet
countertop or in/behind louvered grill.
• Mechanical temperature control is located inside of unit.
See website for adjustments, sequence of operation, and more
information.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful to
load product so that it neither presses against the back wall,
nor comes within four inches of the evaporator housing.
Refrigerated air off the coil must circulate down the back wall.
NOTE:
If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
- Before loading product we recommend
you run your TRUE unit empty for two to three days. This allows you
to be sure electrical wiring and installation are correct and no ship-
ping damage has occurred. Remember, our factory warranty does not
cover product loss!
LIGHT SWITCH LOCATION:
Light switch location depends upon the TUC & TWT freezer glass
door models. Most models will have the light switch located inside
the unit above the door. Most instances the switch is located next to
the light on the ceiling.
OPERATION