Assembly Instructions
6
3.
CABLE CONNECTION
– FRAME AREA
NOTE:
Cables will be labeled near their connector with identifying names such
as those listed below in
BOLD TEXT
. Also listed in these instructions are the
cable part numbers (KDCA-
“xx”), which are called out in each step.
NOTE:
Reference
Wiring Schematic
and
Frame Cable Routing Diagram
at
the end of these Assembly Instructions. You may remove from packet to aid in
assembly but if you remove we recommend you retain these diagrams with the
instructions for future reference.
Step 3-1
CNTRL
Control Cable
i. Route
CNTRL
Cable (KDCA-2B/XL-1063B) from pedestal
towards small circuit board as shown in Step 3.c picture on page
7 and in Fig 3-1.
ii.
Plug
CNTRL
cable connector into small circuit board.
NOTE: 10-pin connector is polarized. Insert properly.
