![background image](http://html.mh-extra.com/html/true/gdm-10/gdm-10_installation-manual_1174080019.webp)
............ www.truemfg.com ............
True Food Service Equipment, Inc.
17
17
REQUIRED TOOLS
s0HILLIPS(EAD3CREWDRIVER
CAUTION
Do NOT remove the gaskets on radi-
us front, (”RF”), coolers.
___________ STEP 1 ____________
/PEN COOLER DOOR AND REMOVE MAGNETIC
DOOR GASKET AGAIN DO NOT REMOVE GAS
KETS ON RADIUS FRONT COOLERS ALONG THE
SIDE OF DOOR OPPOSITE THE HINGE BY PULL
ING THE GASKET OUT OF THE BLACK PLASTIC
RETAINER EXTRUSION 4HIS WILL EXPOSE THE
TWOMOUNTINGHOLESFORTHESCREWWHICH
SECURESTHEHANDLE
___________ STEP 2 ____________
2EMOVE CONTOUR BOTTLE HANDLE FROM ITS
PROTECTIVEPACKAGINGANDREMOVETHETWO
LONGSCREWSFROMTHEBACKSURFACEOFTHE
HANDLE2EMOVETHEPLASTICSPACERSFROM
THESCREWSANDRETAINFORUSELATER
___________ STEP 3 ____________
0USHTHESCREWFROMTHEREARSIDEOFTHE
SWING DOOR BACK THROUGH THE BOTTOM
HOLE 0LACE ONE v LONG SPACER ON THE
SCREWANDFASTENTHESCREWTOTHEBOTTOM
HOLE IN CONTOUR HANDLE $O NOT OVER
TIGHTENTHESCREW
- NOTE -
4HREEHOLECONFIGURATIONONCONTOUR
HANDLEACCOMMODATESDIFFERENTSIZE
COOLERS5SEONLYTHETWOHOLESTHAT
MATCHYOURCOOLERSDOORFRAME
___________ STEP 4 ____________
0USH THE OTHER SCREW THROUGH THE NEXT
HOLE 0LACE THE OTHER v LONG SPACERS
ON THE SCREWS AND FASTEN TO THE HANDLE
4IGHTEN BOTH SCREWS SO THE HANDLE IS
SECUREBUTDONOTOVERTIGHTEN
___________ STEP 5 ____________
2EPLACETHEMAGNETICGASKETINTHE
RETAINEREXTRUSION
INSTALLATION / OPERATION INSTRUCTIONS
- IMPORTANT -
Before installing lamp cover turn
cabinet on and allow it to reach
temperature.
___________ STEP 1 ____________
,OCATERUBBERGASKETBEHINDLAMPHOLDER
MOUNTEDTOEVAPORATORHOUSING
3EE)MAGE
___________ STEP 2 ____________
&IT THE BOTTOM EDGE OF THE LAMP COVER
INTO THE BOTTOM GROOVE OF THE RUBBER
GASKETANDROTATEUPWARDSWHILEWORKING
THEEDGESINTOTHERESTOFTHERECTANGULAR
GROOVE 3EE )MAGES SLIDE FINGERS
UNDERNEATH TOP EDGES OF RUBBER GASKET
AND PUSH RUBBER OVER THE TOP LIP OF THE
LAMPSHIELD
___________ STEP 3 ____________
"ESURELAMPCOVERISSEATEDPROPERLYIN
RUBBERGASKET
- NOTE -
If cabinet is turned off and
interior allowed to warm up lamp
cover may become loose and
require reinstallation. Follow
directions above.
Light Cover Installation for GDM-10F & GDM-12F
Lamp Cover
Rubber
Gasket
Lamp
Holder
1
2
3
Contour Bottle Handle Installation
(Specific Accounts Only)