Cleaning the Vent Pipe:
The products of combustion will contain small particles of flyash and/or soot. The Flyash and/or soot will
collect in the exhaust venting system and restrict the flow of the flue gases. The exhaust venting system
should be inspected at least twice every year to determine if cleaning is necessary. Sweep the liner as
needed. The insert is equiped with clean-out tee in the exhaust system at the transition from horizontal to
vertical making cleaning easier.
Pacific Energy Fireplace Products recommends having your stove inspected
and cleaned by a trained professional.
Cleaning the Convection Blowers
Disconnect power to the stove. Remove the
Surround Panel and Cabinet Sides. (See "Surround
and Cabinet Side Removal" on page 14) . There
is one blower on each side of the firebox.
• A vacuum can be used to remove any dust accu
-
mulation on the blower’s blades or inside the blower
ducts. Caution should be used not to damage the
blower’s blades during cleaning. Vacuum around
the motor.
Reverse the removal process to reinstall the Cabinet
Sides and Suround Panel set.
DOOR GLASS - Replacement
If the glass gets cracked or broken, it must be replaced before using the stove. Replacement glass can be
obtained from your dealer. Use 9-1/4"(235mm) x 13-1/4"(337mm) x 5 mm. Ceramic glass only. Do not sub-
stitute with any other type.
-To remove broken glass, undo the four retaining screws and remove clamps, noting position for
re-assembly. Remove all particles of glass. Be careful as they are very sharp. Install new glass complete
with glass gasket. Replace clamps and screws.
CAUTION:
- do not overtighten, tighten screws very carefully
Figure 8: Blower cleaning.
16
5055.538-A_080317-28
TN40 INS
Operating Instructions
