True Manufacturing Company TAC-14GS-HC-LD, Installation Manual

Page: 16 / 24

TEC_TM_086 REV. B | EN 09/26/22 Page 16 of 24
AIR CURTAIN www.truemfg.com
Maintenance, Care & Cleaning
Fig. 1.
Lower grill screw locations (A). Pull the grill from the cabinet front (B).
Fig. 2. TAC-14GS-LD Grill removal. Lift grill away from cabinet after removing screws.
CAUTION!
- Take care during operation, maintenance
or repairs to avoid cuts or pinching from any cabinet
part/component.
Condenser Coil Cleaning
When using electrical appliances, basic safety precautions should
be followed, including the following:
WARNING!
– Electrical shock or burn hazard.
Unplug the unit or turn off the power supply before
proceeding. DO NOT clean appliance with a pressure
washer or hose.
CAUTION! – Risk of eye injury. Eye protection is
recommended.
CAUTION!
– Coil fins are sharp. Gloves are
recommended.
Required Tools
Procedure
1.
Unplug the unit or turn off the power supply.
2.
Remove the front louver grill. See figs. 1-3.
3.
With a stiff bristle brush, carefully clean accumulated dirt from
the front condenser coil fins. See fig. 4.
4.
With dirt removed from the surface of the coil, use a flashlight
to verify that you can see through the coil and observe the
condenser fan blade. See fig. 5.
NOTE: If your view is blocked, gently blow compressed air
or CO2 through the coil until it is clean.
5.
Carefully vacuum any dirt around the condensing unit area.
6.
Reinstall the louvered grill, connect power to the unit, and
verify operation.
• 1/4" nut driver
• 3/8" nut driver
• Stiff bristle brush
• Tank of compressed air • Vacuum cleaner
• Flashlight
• Eye protection
• Gloves
Fig. 3.
TAC-48SM: Remove the screws and tilt the top of the grill forward.