13
1. The machine should be in its final position.
Depending upon the space surrounding your
machine, either the front or rear shrouds will need
to be removed to install the weight plates. These
instructions will show weight plate installation
with the front shroud removed.
2. Remove the screws securing the front shrouds
(12 per shroud). Lay the shroud down on a flat
surface. DO NOT STAND it up against a wall as it
can easily slide and become damaged.
3. Pull the pins holding the guide rods in place.
4. Tilt the guide rods to the side then forward
as shown.
5. Carefully slide the top plate/selector bar
assembly up and off of the guide rods.
NOTE: It is not necessary to remove the pulley
or cable from the top plate/selector bar
assembly. Have someone hold the top
plate/selector bar assembly to the side while
the weight plates are installed.
6. Install the weight plates, 12 plates per side.
7. Re-assemble the top plate/selector bar
making sure that the cable is not twisted.
8. Re-attach the guide rods to the frame with
the pull pins.
9. You can re-assemble the shroud now or
after you attach the weight plate labels as
shown on the following page.
S
TEP
4: A
SSEMBLE
THE
W
EIGHT
P
LATES
Remove
Front Shroud
Remove Top
Plate/Selector
Bar.
Pull Pins
Guide Rods
