True Blue Power
5
Revision 1, June 15, 2018
Note: Pins should be crimped using Molex Hand Crimp Tool 63819-
0000 (Preferred), 63811-2800 (obsolete) or 11-01-0200 (obsolete).
See the Molex Hand Crimp Tool User Manual for crimp procedures.
3.3.2 Pin Assignment Information
INPUT POWER:
Pin A
(keyed)
– Positive DC input +10 to 32 VDC power
Pin B
– Negative DC input / ground
3.3.3 Harness Verification
WARNING:
Failure to install power and ground wires in the proper mating
connector locations will permanently damage the unit.
Once the cable harness is prepared, prior to connecting the
USBT102, activate the vehicle power bus and use a
multimeter to verify that vehicle power and ground is supplied
with appropriate voltage on the proper pins within the mating
harness.
(M6430102-2, -4)
3.4
MOUNTING
Figure 3.1
The USBT102 can be installed in one of five ways:
Power Input
•
rear mount, rectangular
•
rear mount, circular *
•
instrument mount *
•
front mount, decorative bezel *
•
rear mount, decorative bezel *
* Installation kit required. See Section 3.2, Optional Equipment Available for part number reference
Prepare the panel cutout as shown in Figures 3.3, 3.4, 3.5, 3.6, or 3.7 per the selected mounting option.
•
For Rectangular Rear Mount, Circular Rear Mount and Instrument Mount Installations
countersinks in the panel for flat head screws are optional. However, flat head screws are
provided for flush appearance. For Front and Rear Decorative Bezel Installations, countersinks in
the panel are required.
•
For Rear Mount Installations:
Mounting screws length MUST be between (PT + 0.150”) and (PT +0.260”). [PT = panel
thickness] Mounting screws provided with the unit are 0.24” and 0.31” (accommodates 0.020” to
0.160” PT).
For PT greater than 0.125, the USB connector will be below the surface of the panel (below flush).
•
For Circular Rear Mount Installations:
Mounting screws length MUST be between (PT + 0.200”) and (PT + 0.375”). [PT = panel thickness]
Mounting s
crews provided with the Circular Rear Mount Install Kit are 0.438”.
•
For Front Mount Installation: Maximum panel thickness is 0.25”.
•
For Rear Mount Installation with Decorative Bezel: Panel thickness greater than 0.065 will cause
the USB connector to be below the surface of the bezel (below flush).
Pin A
Pin B
Pin B
Pin A
(
M6430102-1
,
-3
)
