16
Quick set up guide for AirSim Advance and AirSim Advance
Bronchi
1.
Remove models from the black carrier case, with blue bag and
plastic connector.
2. Connect one end of the plastic connector to the open section of the left
Bronchi on AirSim airway.(If applicable)
3. Connect the other end of the plastic connector to the blue lung bag.
(If applicable)
4.
Ensure that the tongue is inflated with approx 20ml of air. This will
create normal lingual tension. Increasing the amount of air will create
a more difficult airway management scenario.
5.
Using
Trucorp’s silicone lubricant ensure that the internal airway and
Nasal passage are well lubricated.
6.
Ensure that all airway devices are prepared to the manufactures
recommendations and instructions. Before insertion of the device
generous amounts of lubricant should be used to cover the surfaces in
contact with the AirSim airway.
7.
Please ensure that the AirSim airway is cleaned after use. Please use
warm water of a dilute (8-10% w/w) Sodium Bicarbonate solution until
all visible foreign matter and residue is removed.
8.
The head and neck skin of the models are made from durable and very
elastic polyurethane material. It can be cleaned using a lightly soaped,
damp cloth. Please do not use and detergents or cleaning agents on
the skin material
9.
Please replace the models unit back into the carrier case and
store in clean, dry conditions away from heat and light; avoid
contact with metals, solvents, oils or greases and strong detergents.
