D301144 0509
Installation PB-XEPI
11
Start-up guideline
The following steps are required for start-up:
1.
Mount the device (see »Assembling the device« on page 12).
2.
Connect to the Ethernet (see »Connecting the Ethernet« on page 12).
3.
Connect to the power supply (see »Connecting the power supply« on page 13)
4.
Configure the Ethernet (see »Configuring the device in the Ethernet network« on
page 14).
5.
Connect the PROFIBUS (see »Connecting the PROFIBUS« on page 18).
6.
If you use the PB-XEPI in the
PROFIBUS network access
operation mode
you have to configure PROFIBUS parameters of the device using an application
software (not included in the scope of delivery).
Note
To set the IP address manually you must connect your computer to the
device via a patch cable.
Note regarding the application software
An application software with the appropriate drivers is required for operating
the device. The COM-DTM for usage of the PB-XEPI in FDT frame
applications is on the CD.
Start-up guideline
