TruXedo Inc.
•
2209 Kellen Gross Drive, Yankton, SD 57078
•
877-878-9336
•
truxedo.com
©
TruXedo Inc. 2020
-
Setting The Hook and Loop Before Operating Vehicle.
Engaging Hook and Loop, Step Two:
With the cover
closed and both hook and loop engaged, use
the palms of your hand to firmly push the loop
strip into the hook track. Do this to both driver
and passenger side up and down the entire
length of the loop seams.
Engaging Hook and Loop, Step One:
After rolling
the cover closed, grab the fabric loop flap and
evenly pull loop over the hook track engaging
the loop to the hook track.
Avoid pulling
fabric flap straight up.
IMPORTANT OPERATING TIPS CONTINUED:
HEADER WILL NOT LATCH:
1. Check side rails to make sure they are level.
2. Make sure the rear header seal is not caught between side rail & rear header.
3. If rear header doesn't latch correctly check side rail installation.
4. Check to make sure side rails are both equally spaced front to rear.
5. Make sure both latches are functioning properly. Clean any debris that may be impeding latches, see
COVER CARE AND MAINTENANCE on page 6.
6. Close tailgate first then cover.
TROUBLESHOOTING
COVER IS HARD TO ROLL OPEN OR CLOSED:
1.
Truck bed cover MUST be free of foreign material including snow and ice before rolling cover.
2. Prolong cold weather will make cover fabric stiff. Move cover into sun or indoors to warm the top surface.
3. It is normal for the cover to experience light binding after being rolled up for an extended period of time.
Once the cover is latched, the fabric will relax and the cover will lay flat.
COVER ASSEMBLY WILL NOT ATTACH TO SIDE RAILS DURING INSTALLATION:
1. Check side rails to make sure they are level.
2. The rolled up cover is heavy which may be flexing the rails downward. Push front of rails up slightly to
allow the screw heads to fall in the slots and the header guides to slide freely into the secured location
(review step 9).
3. If rear header doesn't latch correctly check side rail installation.
TruXedo, Inc. warrants that all new, unused products are free from defects in material and workmanship. This
Three Year Limited Warranty is effective if the product is properly installed and used for the purpose intended.
It applies to the original buyer only. TruXedo's obligation under this Warranty is limited to repairing, or at its
option, replacing any part that is returned, transportation prepaid, to TruXedo, Inc., Yankton, South Dakota, if
the product is, in our judgment, defective. All materials must be accompanied by an RMA (Returned Material
Authorization) number requested by and authorized in advance of returning the materials. TruXedo, Inc. shall
not be liable or responsible to supply or pay labor to replace any part found defective, nor shall it be liable for
any damages of any kind or nature to person, product, or property.
There are no Warranties for used products or products that have been repaired, altered, modified, subjected to
misuse, negligence, accident or ordinary wear and tear. Warranty registration must be on file and/or proof of
original purchase (detailed and dated receipt) required for warranty to be valid. Please locate the serial number
on your cover before registering the warranty. The serial number can be found on the underside of the front
aluminum header bar located on the driver side. Register warranty online at www.truxedo.com
THREE YEAR WARRANTY
DIRECT ALL WARRANTY CLAIMS TO TRUXEDO AT 1-877-878-9336
Page 10
Part# 1118565, Rev. A
