
8
Function
Standard Speaker Installation
• Attach your source to the “line in” or “bus in”
• Set the input switch to the appropriate source.
• Set the ST/BR switch to ST (stereo)
• Now attach your two speakers to the phoenix
connector, left & right channel.
Attach your source to the “line in” or “bus in”
Set the input switch to the appropriate source.
Attach a single RCA wire from the “SUB OUT” of
that zone to a powered subwoofer.
Turn the crossover knob clockwise all the way to the
140Hz position on the D16. Now use the crossover
on your powered subwoofer or subwoofer amplifier.
•
•
•
•
Subwoofer Wiring
(1) Using the Subwoofer RCA output to a stand alone powered subwoofer.
Attach your source to the “line in” or “bus in”
Set the input switch to the appropriate source.
Attach a single RCA wire from the “SUB OUT” for
that zone to the next zone “line in” LEFT channel.
Set the first zone to “ST” and attach your two
speakers to the phoenix connector.
Next set that subwoofer zone to “BR” Bridged and
attach the subwoofer wires to that zone to the
outermost portions of the phoenix connector. (the
bridged terminals)
Now play music and adjust the crossover and the
gain knobs on both zones till you get the music and
subwoofer sounding the way you like. Use your
source volume to increase and decrease the sound.
•
•
•
•
•
•
(2) Outputting a subwoofer signal over speaker wire to the TruAudio IC-SUB-8
passive subwoofer
There are multiple ways to configure setup of a subwoofer on the D16.
1. To an active powered subwoofer or subwoofer amplifier
2. To a passive subwoofer
SOURCE
SOURCE
SOURCE
SPEAKERS
SPEAKERS
SPEAKERS
SUBWOOFER
SUBWOOFER
(Diagram shows input set to “line in”)
(Diagram shows input set to “line in”)