4
Rear Panel
Front Panel LED Lights
Quick Reference Chart
NOTE:
If the channel LED is RED you have a fault and need to fix that issue. Once fixed the light should
go back to BLUE if the zone is being used or OFF if the zone is not being used. Fault is typically the
positive and negitive speaker wire touching.
NOTE:
If one of the clip LED lights is “flashing,” then that zone is clipping. To resolve this, you need to
lower the input source volume and/or lower the gain for that channel until the LED stops flashing.
1. Bus In
2. Bus Out
3. Line In (Analog)
4. Input Switch
5. Input Gain Knob
6. Stero/Bridge Switch
7. Subwoofer Crossover
8. Subwoofer RCA Out
9. Phoenix Speaker Connector
10. Ground Lift Switch
11. On/Auto/Trigger
12. Input Voltage Switch (110v/220v)
13. Trigger In/Out
14. AC Fuse
15. AC Input
T15AL 250VAC FOR 115VAC 60Hz
T10AL 250VAC FOR 230VAC 50Hz
LED COLOR
POWER
CHANNEL
CLIP
BLUE
RED
OFF
BLUE
RED
OFF
RED
OFF
Unit is on
Unit is in standby, no signal
Unit is off
Zone is active
Zone fault
No signal
Source is set to high
Source is set correctly
DESCRIPTION
1
3 4
6
2 7 8
9
10
11
12
13
14
15
5
