8
NOTE: Always check that the water level in the Water Tank is between the MIN and MAX markings before starting a brew
cy
cle. If the Brewer does not have enough water in the Water Tank to complete a brew cycle, then all five buttons will
flash indicating more water must be added to the Water Tank. After water is added, press the corresponding function
button and the brew cycle will continue from where it stopped.
3.
Press the Release Button on the front of the Brewer to release the Capsule Puncturing / Locking Mechanism (
Fig. 1
).
4.
Remove the Slide-Out Brew Chamber from the Brewer.
5.
Insert the Permanent Coffee Filter Basket into the Slide-Out Brew Chamber.
6.
Insert the Brew Chamber Adapter into the Brew Chamber by aligning the 4 tabs on the Adapter with the 4 notches in the Brew
Chamber (
Fig. 2
).
NOTE: There is an alignment indicator on the Brew Chamber Adapter that should be positioned closest to the Brew
Chamber Handle when properly aligned.
7.
Insert the Shower Head Attachment into the center of the Brew Chamber Adapter by aligning the 3 tabs on the Shower Head
Attachment with the 3 notches in the Brew Chamber Adapter (
Fig. 3
).
8.
Replace the Slide-Out Brew Chamber into the Brewer making sure it is completely closed.
9.
Lower the Capsule Puncturing / Locking Mechanism (
Fig. 4
).
NOTE: If the Slide-Out Brew Chamber is not properly closed, the Capsule Puncturing / Locking Mechanism will not
lower and latch.
10.
Turn the Brewer ON by pressing the Power Button. All five buttons will be illuminated (
Fig. 5 shows Brewer Control Buttons
).
11.
Place the Glass Carafe on the Drip Tray (Fig. 6).
NOTE: When using the Glass Carafe, the Drip Tray must always be in place.
12.
Press the 10 Cups Button. The brew cycle will now begin and the 10 Cups button will flash throughout the brewing cycle.
13.
When the brew cycle is complete, the flashing will stop and all five buttons will illuminate. Five minutes after the brew cycle is
complete, the Brewer will automatically shut off.
