19
ADJUSTMENT OF THE LEVERS
Both the clutch lever and the brake lever must have
a maximum initial free play of 3mm. It is important
that this free play exists and you should not disable
it. To adjust, use the adjustment nuts on the levers.
To adapt the handlebar to different types of driving,
you can change the angle by loosening the clamps
that secure it to the fork. Once you have adjusted
it as desired, tighten the bolts again, starting with
those closest to the seat and moving on to those
closest to the speedometer.
The engine has a capacity of 350 cc of transmis-
sion oil.
Do not mix different types of oil. Always top up
using the same type. We recommend using oil
such as ATF DEXROOM III.
15 - Adjustment of the levers and the handlebar
16 - Checking the oil level
/
/
17 - Changing the transmission oil
CHANGING THE TRANSMISSION OIL
There is a plug on the bottom of the sump for drai-
ning the oil Fig(b) and another in the upper part for
filling Fig(a). To change the oil, start the motorcycle
with a cold engine and let it run at idle speed for 5
minutes. This will warm up the oil to the right tem-
perature for changing.
Then place the motorcycle in driving position with
a container below and remove the drain plug. Let
all of the oil drain out, and then clean the plug, re-
moving any metal shavings. Once it is clean, repla-
ce it and refill the engine through the opening on
the top, until reaching the desired level in the sight
level glass.
TRS Motorcycles recomends NILS.
Fig (b):Oil drain plug at the bottom of the sump
a) Oil filler cap, in the upper part of the sump.
Maximum initial free play of both levers of the handlebar.
a
b
Summary of Contents for One 250 2016
Page 1: ...User Manual 250 280 300 2016 ...
Page 2: ...2 ...
