Troyka Med Inc
IOSB Mah. 2284. Cad No: 48 Yenimahalle Ankara TURKEY
Tel:
+90 5325128580- [email protected] –
www.troykamed.com
T-280 MRI Conditional Dom Camera Op. Man. Pub. 022018 Pub. No: 0 Rev:0
and 9 pin cable shown in the Figure 2-2 and 3 must be connected to the penetration panel. Most of the MRI
scanners has BNC and 9 pin filters available on the penetration panel. If there is no available filter on your
penetration panel use the ones included in your package (Table 1- 4 and Table 1-5).
The interface box must be placed in the cabinet room. The female 9 pin connector of the interface box must
be connected to the male connector of the 9-pin filter (Figure 2-5) of the penetration panel the video signal
cable must be connected to the BNC filter. The power cable of the interface box must be connected to the
power outlet. The 30m video signal cable of the interface box must be connected to the video processing
unit in operation room. Using VGA cable connects the video interface unit to the monitor and the system will
be ready to use.
In order to power on the camera, turn on the power switch which is available on the interface unit (Figure 2-
9).
Figure 2:
MR conditional dome type video camera installation diagram.
3.4.2. MRI Camera Installation diagram
The representative drawing showing the installation diagram of the MRI camera is given in Figure 3. Use 4
screws delivered in the package to mount the base part of the camera (Figure 3-1) to the wall as is shown in
Figure 3. After that, place the camera into the base and put the component 3 (figure 3-3) over the camera
then place on the component 4 on whole assemble and screw it. Adjust proper direction of the camera and
tighten the component not to let camera move.
Adjust the focus and zoom settings of the camera. For the adjustment use thin flat screwdriver. Place the
screwdriver into the zoom or focus hole that is shown on the figure 3-5. Screwing it adjust the desired zoom
and focus setting for optimal image quality.
1. MRI Camera
2. Video signal
cable
3. 9 Pin cable
4. BNC Filter
5. 9 pin filter
2. Video signal
cable
3. 9 Pin cable
Power Outlet
6. Interface Box
2. Video signal
cable
7. Video converter unit
8. Monitor
Magnet Room
Cabinet Room
Operator Room
9. Power Switch
