Assembly of Aluminum T-14 Pole with Mounting Kit and T-14 House Mount
Step 19)
It is time to install the houses. Begin by
removing the houses from their boxes (one sec-
tion of house per box). One of the house sections
will have a hardware bag containing 8 carriage
bolts and 8 wing nuts. Begin by getting 4 of the
carriage bolts On the back side of each of the
four unit houses you will see a rail to the left and
right with holes at the top and bottom of the rails.
Insert a carriage bolt so the flat head of the car-
riage bolt is inside the rail, repeat for all 4 holes.
Take a hammer and gently tap the carriage head
to be sure they are fully seated and tight against
the rail.
Step 20
) Now you will need two of your slider
blocks (O) (found in the mounting kit). Note that
each block has screws installed in them. Place
one of the slider blocks underneath the upper car-
riage bolts and using your hammer tap the slider
block so that its flush with the back of the house.
Now use your hammer and tap the bottom of the
block, upwards so that you move the block to
where the edge of the block is pushing on the
carriage bolt head. Partly covering these bolt
heads will help later in the installation as it will
keep the bolts from moving. Using you screw dri-
ver install the screws. Repeat at the lower section,
and do the other 4-section.
Step 21)
In the mounting kits hardware bag there
are 8 wood screws (S). You will take a screw and
insert the screw from outside the rail of the four-
house section, thru the slider block. Insert one
screw to the left and the right of all 4 slider
blocks. The back of your two 4-compartment
sections should look like this. See photo step 21
next page.
©2023 Troyer’s Birds’ Paradise LLC. 20785 Morris Rd. Conneautville, PA 16406 814-587-2756 Page 7
Notice the
cable on the
safety pin
Step 18
Step 19
Step 20
Step 21
