2.5mm
Tail wheel
Washer(3x15mm)
Screw (3x65mm)
Lock Nut (3mm )
Clevis
Aluminum tube
Steel wire
2
Steel wire (0.5x1200mm)
1
3
2
2
Clevis
Retainer
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x65mm)
2
Copper joiner
The sketch map after the rudder shaft assemble finished.
The sketch map for the linkage of the rudder
and the tail wheel and elevator in the fuselage.
3mm
30mm
Retainer
TP Screw (2.3x8mm)
8
TP Screw (2.3x8mm)
Ply (15x15x3mm)
8
Collar
Tail landing gear
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Drill a small hole to appropriate possition in the
fuselage for installing the plastical tube.
15mm
45mm
2
Plastical tube(3x50mm)
Drill a hole to appropriate position in the
rudder as illustration.
Epoxy plies to appropriate position in the fuselage and
assemble the tail gear cover with screw.
Then assemble the wheel as illustration.
50
51
53
54
10
49
52
1.5mm
TP Screw (2.3x12mm)
8
TP Screw (2.3x12mm)
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x35mm)
Screw (2x10mm)
3mm
Wood dowel (6x50mm)
Blind Nut (6mm)
Screw (6x50mm)
Gear door
Wheel (100mm)
TP Screw (3x20mm)
Washer (3x6mm)
Wooden Block(25x15x13mm)
PVC part
Retracts strut
LockNut(4mm)
Wooden Block
Note:rubber wheels oleo struts
and retracts are optional.
5mm
Cut away the surplus parts of plastic cover
carefully along the shaded line.
Main wing joiner
Rib template (3mm ply)
PVC part
2
2
2
1
2
8
2
8
4
2
1
1
2
2
Wood dowel (4x30mm)
Reinforcement Plate
1
LockNut(4mm)
Mount the gear door and the wheel to the retract.
Cut away the shaded portion for assembling
the gear house.
Secure the servo.Install the nylon control horn
and connect the linkage.
The position of the control horn for flap in the wing.
12
13
11
15
3
14
Accessory list for the coming installation steps.
