Steel wire
Aluminum tube
Clevis
Lock Nut (3mm )
Washer(3x15mm)
Screw (3x80mm)
28mm
118mm
2
Plastical tube(3x60mm)
3mm
3mm
1mm
Rudder
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
2.5mm
Keep some space about 1mm width between
the tailing edge and the rudder.
Drill holes to relevant position in the vertical fin and
assemble the rudder to the fuselage with epoxy glue.
Drill holes to appropriate position in the tail fuselage
for connect the rudder and rudder servo.
Epoxy the plastical tubes to the holes as illustration.
The sketch map once the connection between the
rudder and rudder servo assemble completion.
Drill holes to the relevant position in the rudder for
assembling the shaft for control the rudder.
51
50
53
52
54
10
49
1.5mm
Clevis
Retainer
Rod (2x300mm)
Screw (2x10mm)
TP Screw (2.3x12mm)
3mm
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x50mm)
2
Main wing joiner (25x270mm)
2
Main wing joiner (16x270mm)
Wood dowel (8x60mm)
2
2
2
Blind Nut (8mm)
Screw(8x60mm)
Reinforcement Plate
1
PVC
1
A = A"
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A"
A
Washer (4x12mm)
Rib template
8
8
Screw (4x16mm)
2
1
2
2
Collar (8x4mm)
Wheel (100mm)
2
Screw (20mm)
2
Lock Nut (4mm )
Fiber board(100x15x2mm)
Trim the holes until they fit the
screw very well.
Marked place
4
4
Screw (3x15mm)
4
Washer (3x6mm)
6
TP Screw (2.3x12mm)
4
Screw (3x10mm)
Screw (3x10mm)
4
Washer (3x6mm)
2
Main wing joiner (25x270mm)
2
Main wing joiner (16x270mm)
Fiber board(100x15x2mm)
4
2
Ply (9mm)
oleo strut
Install the nylon control horn and connect the linkage.
Secure the servo.Install the nylon control horn and
connect the linkage.
The sketch map when the wings assemble completion.
Put the fiber boards into the main wing until the screw can
fix them very well and mark the position as illustration.
.Epoxy the fiber board to the side wing until the
marked position.
12
14
13
11
15
3
Accessory list for the coming installation steps.
