18
TP Screw (2.3x8mm)
Ply (15x15x3mm)
18
TP Screw (2.3x8mm)
8
TP Screw (2.3x8mm)
Ply (15x15x3mm)
8
1.5mm
Canopy
1
Throttle servo
Rudder servo
Elevator servo
Rudder servo
The sketch map when the servos install completion.
Mount the receiver and the battery to the fuselage.
Trim the cowling for engine and muffler.
Epoxy plies to appropriate position on the fuselage which
under the cowl and assemble the cowl to the fuselage
with TP screws.
Cut off the surplus portion careful along the shaded line.
60
62
63
64
12
61
Accessory list for the coming installation steps.
1mm
Aileron
Tailing
edge
Make sure they are in
the right position while
installing.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Make sure hinges are
mounted in the same line.
8
8
2
2
2
4
2
2
2
2
Clevis
Rod (2x300mm)
Retainer
TP Screw (2.3x12mm)
Wooden Block(20x20x8mm)
Servo tray(68.5x56.5x2mm)
Pin hinge(24x24mm)
Screw (3x60mm)
Washer(3x15mm)
2
Washer(3x15mm)
Lock Nut (3mm )
Clevis
Retainer
Rod (2x300mm)
Screw (2x10mm)
8
Pin hinge(24x24mm)
Install the servo as the illustration below
Install the nylon control horn and connect the linkage.
Apply instant type CA glue to aileron and pin hinge.
Keep some space about 1mm width between
aileron and trailing edge.
Assemble the aileron to main wing with instant type CA glue.Be careful
to ensure the moving parts of the hinges are able to move freely.
1
2
3
4
5
1
Accessory list for the coming installation steps.
