![background image](http://html.mh-extra.com/html/troy-bilt/tb430/tb430_operators-manual_1172692009.webp)
9
STARTING AND STOPPING
WARNING:
Operate this unit only in a well-ventilated
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
position when pulling the starter rope (Fig. 5).
STARTING INSTRUCTIONS
1. Mix gasoline with oil. Refer to
Oil and Fuel Mixing Instructions
.
2. Fill the fuel tank. Refer to
Fueling the Unit
.
NOTE:
There is no need to turn the unit on. The On/Off switch is in
the ON ( I ) position at all times (Fig. 3).
3. Slowly press and release the primer bulb
10 times
(Fig. 4). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Move the cruise control to the
SLOW
position (Fig. 3).
NOTE:
Keep the cruise control in the
SLOW
position and
DO NOT
squeeze the throttle control until step 9 (Fig. 3).
5.
DO NOT
squeeze the throttle control. Flip the choke lever
clockwise until it clicks into the
START
position (Fig. 4).
6.
DO NOT
squeeze the throttle control. Crouch in the starting
position (Fig. 5).
7.
DO NOT
squeeze the throttle control. Pull the starter rope with a
controlled and steady motion until the unit starts.
8.
DO NOT
squeeze the throttle control. Idle the engine for 5 to 10
seconds. If the unit stops during this time, squeeze and hold the
throttle control or move the cruise control to the
FAST
position
(Fig. 3), then pull the starter rope in a controlled and steady
motion until the unit starts.
9. Squeeze and hold the throttle control or move the cruise control
to the
FAST
position (Fig. 3). Allow the engine to warm up for 30
to 60 seconds.
NOTE:
The engine is properly warmed up when it accelerates
without hesitation.
NOTE:
Once the engine is properly warmed, the cruise control may
be adjusted and the throttle control can be used normally.
IF...
the engine hesitates, return the cruise control to the
SLOW
position and repeat steps 8 - 9.
IF...
the engine does not start, begin the starting procedure with
step 3.
IF...
the engine fails to start after a few attempts: Squeeze and hold
the throttle control or move the cruise control to the
FAST
position. Pull the starter rope with a controlled and steady
motion until the unit starts.
IF...
the engine is already warm: Squeeze and hold the throttle
control or move the cruise control to the
FAST
position. Pull the
starter rope with a controlled and steady motion until the unit
starts.
STOPPING INSTRUCTIONS
1. Release the throttle control, or move the cruise control to the
SLOW
position, and allow the engine to idle.
2. Press and hold the On/Off switch in the
OFF (O)
position until
the engine comes to a complete stop (Fig. 3).
WARNING:
When starting the unit, make sure it is not
directed toward people, animals, windows, automobiles or
loose debris.
Fig. 3
Fig. 5
On ( I )
Off (O)
Throttle Control
Starting
Position
Starter Rope Grip
Fig. 4
Primer Bulb
Choke Lever
Cruise
Control
SLOW
FAST
Summary of Contents for TB430
Page 15: ...15 NOTES ...
Page 31: ...31 NOTAS ...