Connecting the Battery Cables
CALIFORNIA PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION:
When attaching battery cables, always
connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
For shipping reasons, one or both battery cables on your
equipment may have been left disconnected from the terminals
at the factory. To connect the battery cables, proceed as follows:
NOTE:
The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked Neg. (–).
NOTE:
If the positive battery cable is already attached, skip ahead
to step 2.
Remove the plastic cover, if present, from the positive battery
1.
terminal and attach the red cable to the positive battery
terminal (+) with the bolt and hex nut. See Fig. 3-3.
Remove the plastic cover, if present, from the negative battery
2.
terminal and attach the black cable to the negative battery
terminal (–) with the bolt and hex nut. See Fig. 3-3.
Position the red rubber boot over the positive battery terminal to
3.
help protect it from corrosion.
NOTE:
If the battery is put into service after the date shown
on top/side of battery, charge the battery as instructed in the
Maintenance section your Operator’s Manual prior to operating
the tractor.
Checking Tire Pressure
WARNING!
Do not overinflate tires. Check sidewall
of tires for maximum psi. Equal tire pressure should
be maintained at all times.
The tires on your tractor may be over inflated for shipping
purposes. Reduce the tire pressure before operating the tractor.
Check sidewall of tires for maximum psi.
Setting the Deck Gauge Wheels
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows
Select the height position of the cutting deck by placing
1.
the deck lift lever in the normally desired mowing height
setting (any of the six different cutting height notches on
the right fender).
Check the gauge wheels for contact or excessive clearance
2.
with the surface below. The deck gauge wheels should
have between ¼” and ½” clearance above the ground as
follows:
If the gauge wheels have excessive clearance or contact with the
surface, adjust as follows:
Raise the deck lift handle to its highest setting.
a.
Remove the front and rear gauge wheels by
b.
removing the lock nuts and shoulder screws which
secure them to the deck. See Fig. 3-4
Place the deck lift lever in the desired mowing height
c.
setting.
Reinsert the shoulder screw (with each gauge
d.
wheel) into the index hole that leaves approximately
½-inch between the bottom of the wheel and the
pavement.
Refer to Leveling the Deck in the Maintenance & Adjustments
section of this manual for more detailed instructions regarding
various deck adjustments.
Figure 3-3
Figure 3-4
10
s
ectiOn
3 — a
sseMbly
& s
et
-u
p
Summary of Contents for TB2450
Page 33: ...Notes 11 33...
