![background image](http://html.mh-extra.com/html/troy-bilt/storm-tracker-2690/storm-tracker-2690_operators-manual_1173300007.webp)
Assembly
Handle
Place the shift lever in the Forward-6 position.
1.
Remove the lower plastic wing nut and carriage bolt from
2.
each side of the upper handle; raise the upper handle
assembly until it snaps over the lower handle. See Fig. 3-1.
NOTE:
Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
Looking beneath the handle panel, check that all of the
3.
cables (steering, auger, shift, and drive) are properly routed
and not pinched or kinked.
Secure the handle by tightening the plastic knob located
4.
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly
Remove cotter pin, wing nut and hex screw from chute
1.
control head. Remove clevis pin and bow-tie cotter pin
from chute support bracket. See Fig. 3-3.
Figure 3-1
Chute Control Head
Chute
Chute Support
Bracket
Chute Base
Figure 3-3
Figure 3-2
Assembly & Set-Up
3
7
Contents of Crate
One Snow Thrower
•
Two Replacement Auger Shear Pins
•
One Chute Assembly
•
One Snow Thrower Operator’s
•
Manual
One Product Registration Card
•
One Chute Control Rod
•
One Engine Manual
•