![background image](http://html.mh-extra.com/html/troy-bilt/snow-tracker-2690/snow-tracker-2690_operating-manual_1173277018.webp)
NOTE:
When lubricating the hex shaft, be careful not to get
any oil on the aluminum drive plate or the rubber friction
wheel. Doing so will hinder the snow thrower’s drive
system. Wipe off any excess or spilled oil.
Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the flange bearings found at either end of the shaft.
See Fig. 6-4.
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved adjust the shift cable as follows:
Place the shift lever in the fastest forward speed position.
1.
Loosen the hex nut on the shift cable index bracket. See
2.
Fig. 6-5.
Pivot the bracket downward to take up slack in the cable.
3.
Retighten the hex nut.
4.
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
Chute Assembly
Refer to the Assembly and Set-up section for instructions on
adjusting the chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.
Shear Pin
Bow-Tie Cotter Pin
Figure 6-4
Figure 6-5
18
s
ectiOn
6— M
aintenance
& a
djustMents
Summary of Contents for Snow Tracker 2690
Page 29: ...Notes 11 29 ...