Rudder
Vertical
fin
Cut away the rubber tube when
the epoxy glue dried.
1mm
Make sure they are in
the right position while
installing.
2.5mm
6
Pin hinge(24x24mm)
Make sure hinges are
mounted in the same line.
Metal arms
Rod (3x200mm)
3
Pin hinge(2.5x48mm)
Using rubber tubu cover
the middle of the hinges
before installation in case
the epoxy glue get into.
2.5mm
Make sure hinges are
mounted in the same line.
3mm
82mm
72mm
76mm
3mm
1
Wooden Block (6mm Ply)
1
1
Screw (2x10mm)
Nut (2mm )
1
Copper ball (2mm )
Nut (2mm )
Screw (2x10mm)
Copper ball (2mm )
3mm
160mm
2mm
3mm
Trim the shaded section
keep some space about 1mm width between the
vertical fin and rudder
Apply instant type CA glue to aileron and pin hinge.
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Epoxy a wooden block at appropriate position in fuselage,
and drillahole in the centre.
Assemble the ball joint to the metal arms.
Drill holes to appropriate position in the rudder and
epoxy the pin hinges in them
6
32
31
30
27
29
28
1
Matal tube (3x600mm)
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Fuel supply line
Fuel spray line
Air pressure line
3mm
3mm
Install the throttle servo to appropriate position in the
fuselage.
Epoxy the fuel tank in the fuselage.
Install the switch and the throttle servo
Drill a small hole in appropriate position for throttle.
Assembly of the fuel tank.
The sketch map when the engine install completion.
11
60
58
55
56
57
59
