1
Safety
1.1 Correct use
The electronic control component type Easy is used in
combination with a TROX volume flow controller for var-
iable volume flow rate control in ventilation and room air
conditioning systems (HVAC systems).
The control components Easy (controllerEasy for short)
is designed for use indoors to control clean room air.
Supply air area of application:
–
The usual conditioning in air conditioning sys-
tems allows the use of the Easy controller in the
supply air without additional dust protection
measures.
Extract air area of application:
–
Extract air with a low content of dust or lint (e. g.
office) allows the use of the Easy controller
without additional dust protection measures.
–
For dry extract air with a higher proportion of
dust or lint, a suitable filter must be used in front
of the VAV terminal unit.
–
For extract air with a high content of dust, lint or
sticky components, or extract air with aggressive
operating fluids, use a controller with a static dif-
ferential pressure transducer, e. g. TROX Com-
pact controller.
–
In kitchen air extract systems, a VAV terminal
unit may only be used if it has been ensured that
the extract air is cleaned as well as possible by
highly effective aerosol separators, observe
VDI 2052.
In unspecified applications, or when combined with pol-
luted air (e. g. dust) and moisture, a controller with static
differential pressure transmitter should be used, e. g.
TROX Compact controller or universal controller.
Incorrect use
WARNING!
Danger of injury or risk of damage to property
due to incorrect use!
Misuse of the control component can lead to dan-
gerous situations.
Never use the control component/device:
–
in explosion-proof areas
–
in aircraft
–
outdoors without sufficient protection against the
effects of weather
–
in humid air (even temporarily, i. e. in wet areas,
such as bathrooms with showers)
–
for areas of application that are not described in
this manual
Modifying the unit or using replacement parts that have
not been approved by TROX is not permitted.
1.2 Safety signs
The following symbols and signs are usually found in
the work area. They apply to the very location where
they are found.
WARNING!
Danger due to illegible signage!
Over time, stickers and signs may fade or become
otherwise illegible, meaning that hazards cannot be
identified and necessary operating instructions
cannot be followed. There is then a risk of injury.
–
Ensure that all of the safety, warning and oper-
ating information is clearly legible.
–
Replace illegible signs or stickers immediately.
Electrical voltage
Only skilled qualified electricians are allowed to work in
areas marked as having electrical voltage.
Unauthorised persons must not enter areas, open cabi-
nets or work on components where an electrical voltage
is present and which are hence marked with this
symbol.
1.3 Residual risks
The VAV terminal unit is state of the art, and designed in
accordance with current safety requirements. Residual
risks cannot be excluded, however, and you should pro-
ceed with caution. This section describes the residual
risks that have been identified in a risk assessment.
Always observe the safety notes in this manual to
reduce health hazards and prevent any hazardous sit-
uations.
Safety
Residual risks
Control component Easy for VAV terminal units
6
