EN
7
wet and dry vacuum cleaner VC 1200W
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
•
Check the contents of the packaging for completeness and
look for damages.
Warning of electrical voltage
Electric shock due to insufficient insulation!
Check the device for damages and proper functioning
before each use.
If you detect damages, do not use the device any
longer.
•
Dispose of the packaging material according to the
national regulations.
Mounting the wheels
Prior to initial start-up, the swivel castors (
8
) and wheels (
13
)
supplied must be mounted. To do so, please proceed as follows:
1. Insert the two swivel castors (
8
) into the respective
opening on the bottom of the device.
2. Fasten the larger wheels at the rear (
13
) with two screws
each.
ð
The wheels (
13
) will click into place.
13
8
Utilising the air intake opening and air outlet opening
You can use the device for suction or also for blowing out air.
Suction function/spray suction function:
ü
The device is switched off.
1. Insert the connection end of the hose (
1
) into the air intake
opening (
6
).
2. Turn the hose (
1
) in clockwise direction until it clicks into
place (
I.
).
3. To use the spray suction function, insert the end of the
detergent pipe (
2
) into the fitting (
22
).
4. Tighten the end of the detergent pipe in clockwise
direction (
II.
).
Blow function:
ü
The device is switched off.
1. Insert the connection end of the hose (
1
) into the air outlet
opening (
3
).
2. Turn the hose (
1
) in clockwise direction until it clicks into
place (
I.
).
ð
The detergent pipe is not connected.
I.
II.
3
1
2
6
22