8
EN
hand-held vacuum cleaner VC 10-20 V
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
•
Check the contents of the packaging for completeness and
look for damages.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Connecting motor housing and collection container
Before start-up, the motor housing (
3
) needs to be connected to
the collection container (
5
). To do so, please proceed as follows:
1. Fit the collection container (
5
) onto the motor housing (
3
) in
a way that the recess (
9
) at the bottom of the collection
container is seated on the tongue beneath the motor
housing.
2. Slide the collection container (
5
) onto the motor housing (
3
)
until the release button (
8
) snaps into place.
5
3
8
9
3. Check whether the collection container (
5
) is firmly seated
on the motor housing (
3
).
ð
Collection container (
5
) and motor housing (
3
) are
connected.
•
Dispose of the packaging material according to the
national regulations.
Charging the battery
Note
The battery can be damaged in case of improper
charging.
Remove the charger's mains plug before inserting or
removing the battery.
Never charge the battery at ambient temperatures
below 10 °C or above 40 °C.
The battery is partially charged upon delivery to avoid damage
to the battery caused by a deep discharge.
Prior to initial start-up and when the battery is low (only the
red LED in the battery level indication (
17
) is illuminated), the
battery should be charged. To do so, please proceed as follows:
1. Slide the battery (
16
) onto the quick charger (
13
) as
depicted until the battery locks in place.
1 h
16
13
15
14
17
2. Insert the mains plug of the quick charger (
13
) into a
properly fused mains socket.
ð
The red battery LED (
14
) lights up.
ð
Charging requires approx. one hour.
3. Wait until the red battery LED (
14
) goes off and the green
battery LED (
15
) lights up.
ð
The battery (
16
) is fully charged.
4. Hold onto the mains plug while pulling the power cable of
the quick charger (
13
) out of the mains socket.
ð
The battery (
16
) and the quick charger (
13
) may have
become warm during charging.
Allow the battery (
16
) to cool down to room
temperature.
5. Take the battery (
16
) out of the quick charger (
13
) by
pressing and holding the release button (
18
) and pulling
the battery (
16
) off the quick charger (
13
).
Info
The device cannot be started when the charger is
connected.
