EN
11
hand-held vacuum cleaner VC 10-20 V
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with wet or
damp hands.
•
Switch the device off.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Safety signs on the battery and the charger
Check the safety signs attached to the battery and the charger
at regular intervals. Replace illegible safety signs!
Cleaning
The device should be cleaned before and after each use.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
Info
Empty the collection container (
5
) and clean the dust
filter (
7
) after each application to prevent a motor
overload and so as not to reduce the device efficiency.
Emptying the collection container
Please proceed as follows to empty the collection container:
ü
The device is switched off.
1. Hold the device so that the collection container (
5
) points
downwards.
2. To open the collection container, press the release
button (
8
) and remove the collection container (
5
).
8
5
3
3. Remove the dust filter (
7
) from the collection container (
5
).
4. Empty the collection container (
5
) and rinse it with water, if
necessary. Allow the collection container
5
) to air-dry.
5. Reattach the dry collection container (
5
) to the motor
housing (
3
) as described in Connecting motor housing and
collection container.
