EN
4
Operating manual – dehumidifier TTR 56 E
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a carry
handle.
Before
transporting the device, observe the following:
•
Switch the device off.
– Due to the follow-up time of the internal components,
the device only switches off completely after approx. 2
minutes.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
Leave the device to rest for one hour before switching it
back on. Otherwise the device could be damaged and no
longer work properly. Any warranty claims will be voided in
this case.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Empty and clean the condensation tank prior to storage.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Air filter
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
When positioning the device, keep a sufficient distance to
heat sources.
•
Make sure that no curtains or other objects interfere with
the air flow.
